Note: CMIT-LFM simulation runs submitted before October 31, 2018 used solar wind data propagated to the model run's upstream (sunward) boundary (typically at Xmax=30 RE).
However, the model assumes solar wind to be propagated to X=0 instead, causing features in the solar wind to occur in the LFM model simulation a few minutes earlier than expected (for example, 8 minutes earlier for Vx=-400 km/s and Xmax=30 RE).
The propagation has been adjusted in the run request system for "event" runs with CMIT-LFM where solar wind data are obtained automatically from one of the available solar wind monitor spacecraft or data sources (solar wind data in uploaded file are not propagated and need to be adjusted before file upload to make LFM runs comparable to runs of the other magnetosphere models).

Run Metadata
Metadata as JSON:View Full Run Metadata as JSON
 
Model Domain:GM
Model Name:LFM
Model Version:LTR-2_1_5
Title/Introduction:modeled AL
Key Word:dipole tilt +35
 
Run type:Simulation with modeled conditions
Inflow Boundary Conditions:Time-dependent
Start Time:2000/01/02 00:00
End Time:2000/01/02 04:00
Dipole Tilt at Start in X-Z Plane:34.77 °
Dipole Tilt in Y-Z GSE Plane:-0.02 °
Dipole Update With Time:no
Ionospheric Conductance:auroral
Radio Flux 10.7 cm:150
Co-rotation:No corotation velocity is applied at the inner boundary
Grid:106x96x128 cells
Coordinate System for the Output:SM
Solar wind input source:user-defined
Ring current model:RCM
Initial Solar Wind (SW) Parameters in SM Coordinates:
  SW Density:5.00000 n/cc
  SW Temperature:200000.00000 Kelvin
  X Component of SW Velocity:-500.00000 km/s
  Y Component of SW Velocity:0.00000 km/s
  Z Component of SW Velocity:0.00000 km/s
  IMF Bx:0.00000 nT
  IMF By:-5.00000 nT
  IMF Bz:-5.00000 nT
  IMF |B|:7.07000 nT
  IMF Clock Angle:-135.00000 °
 
Input Data
  • View solar wind input data
  • List solar wind input data in ASCII format (see format description here).
    • Runs with Overlapping Dates (57 matches)
    Click on model name to expand the list
    Similar Runs
    Click to expand and modify similarity search criteria