Note: CMIT-LFM simulation runs submitted before October 31, 2018 used solar wind data propagated to the model run's upstream (sunward) boundary (typically at Xmax=30 RE).
However, the model assumes solar wind to be propagated to X=0 instead, causing features in the solar wind to occur in the LFM model simulation a few minutes earlier than expected (for example, 8 minutes earlier for Vx=-400 km/s and Xmax=30 RE).
The propagation has been adjusted in the run request system for "event" runs with CMIT-LFM where solar wind data are obtained automatically from one of the available solar wind monitor spacecraft or data sources (solar wind data in uploaded file are not propagated and need to be adjusted before file upload to make LFM runs comparable to runs of the other magnetosphere models).

Run Metadata
Metadata as JSON:View Full Run Metadata as JSON
 
Model Domain:GM
Model Name:LFM
Model Version:LTR-2_1_5
Title/Introduction:Dipole Tilt Fixed Conductivity
Key Word:Northward IMF
 
Run type:Simulation with modeled conditions
Inflow Boundary Conditions:Time-dependent
Start Time:2004/12/05 00:00
End Time:2004/12/06 00:00
Dipole Tilt at Start in X-Z Plane:-25.67 °
Dipole Tilt in Y-Z GSE Plane:3.51 °
Dipole Update With Time:yes
Ionospheric Conductance:constant
Radio Flux 10.7 cm:0.00000
Co-rotation:Corotation potential is being applied
Grid:106x48x64 cells
Coordinate System for the Output:SM
Solar wind input source:ACE-L2
Initial Solar Wind (SW) Parameters in SM Coordinates:
  SW Density:15.09600 n/cc
  SW Temperature:131949.00000 Kelvin
  X Component of SW Velocity:-446.49000 km/s
  Y Component of SW Velocity:5.94500 km/s
  Z Component of SW Velocity:39.82600 km/s
  IMF Bx:0.28300 nT
  IMF By:-3.57700 nT
  IMF Bz:-0.41500 nT
  IMF |B|:3.60000 nT
  IMF Clock Angle:-96.62000 °
 
Input Data
  • View solar wind input data
  • List solar wind input data in ASCII format (see format description here).
    • Runs with Overlapping Dates (58 matches)
    Click on model name to expand the list
    Similar Runs
    Click to expand and modify similarity search criteria