Note: CMIT-LFM simulation runs submitted before October 31, 2018 used solar wind data propagated to the model run's upstream (sunward) boundary (typically at Xmax=30 RE).
However, the model assumes solar wind to be propagated to X=0 instead, causing features in the solar wind to occur in the LFM model simulation a few minutes earlier than expected (for example, 8 minutes earlier for Vx=-400 km/s and Xmax=30 RE).
The propagation has been adjusted in the run request system for "event" runs with CMIT-LFM where solar wind data are obtained automatically from one of the available solar wind monitor spacecraft or data sources (solar wind data in uploaded file are not propagated and need to be adjusted before file upload to make LFM runs comparable to runs of the other magnetosphere models).
|Metadata Record:||View Full Run Metadata in the CCMC Metadata Registry (CMR)|
|Metadata as JSON:||View Full Run Metadata as JSON|
|Key Word:||dB/dt Challenge test runs 2011|
|Run type:||Real event simulation|
|Inflow Boundary Conditions:||Time-dependent|
|Start Time:||2006/12/14 12:00|
|End Time:||2006/12/16 00:00|
|Dipole Tilt at Start in X-Z Plane:||0.00 °|
|Dipole Tilt in Y-Z GSE Plane:||0.00 °|
|Dipole Update With Time:||yes|
|Co-rotation:||No corotation velocity is applied at the inner boundary.|
|Coordinate System for the Output:||SM|
|Initial Solar Wind (SW) Parameters in SM Coordinates:|
|SW Density:||1.52700 n/cc|
|SW Temperature:||112070.28000 Kelvin|
|X Component of SW Velocity:||0.00000 km/s|
|Y Component of SW Velocity:||0.00000 km/s|
|Z Component of SW Velocity:||0.00000 km/s|
|IMF Bx:||0.00000 nT|
|IMF By:||-2.55700 nT|
|IMF Bz:||-2.07500 nT|
|IMF |B|:||3.29000 nT|
|IMF Clock Angle:||230.90000 °|
- View TIE-GCM data
- View Timeseries in TIE-GCM data
- Pre-computed time series outputs not available
This interface has been recently updated. If you experience problems or have any questions please contact the CCMC staff.